The Lookah Q7 Mini is a smaller, sleeker, and more user-friendly version of the previous Lookah Enails. It has a 950mAh battery that provides between 80 and 100 uses on a single charge.

For a better flavor profile, it employs the 710-thread quartz atomizer range. There are four different coil types to choose from, allowing you to customize your heat and flavor profile. The Q7 mini, like its predecessor, will fit most 14mm to 18mm pipes. A silicon sheath for the downstem allows for use with smaller joint pipes, which can be removed when using larger dab rigs.

With a double click of the power button, the Q7 mini's voltage settings can be adjusted.

Modes 1 and 2 are 3.2V, 3.6V, and 4.0V, respectively. The temperature is adjusted between 350 and 450 degrees Fahrenheit using these settings. These low vaping temperatures aid in the preservation of terpenes and flavonoids, resulting in a more flavorful vaping experience.

Instructions:

• Insert the Q7 mini into your water pipe's downstem.
• Open the magnetic flip cap and insert a small amount of wax into the atomizer coil's center.
• Snap the flip cap shut.
• To turn on the Q7 Mini enail, press the power button 5 times in 2 seconds.
• As the preheat is active, the device will enter a preheat mode, and the display will show a countdown from 9 to 0.
• The light will flash twice after the preheat is complete.
• To change the voltage mode, press the power button twice.
• To heat the atomizer and vaporize the wax, press and hold the power button for up to 10 seconds.

Inhale through the water pipe's mouthpiece. You can adjust the airflow as needed by covering the carb with the flip cap.

After you've finished using the device, wipe around the atomizer to remove any excess wax and turn it off.

How to Care for Your Q7 Mini Enail

1. Remove the magnetic carbohydrate lid.

2. Unscrew the 710 thread atomizer counterclockwise to remove it.

3. Unscrew the downstem counterclockwise.

4. Clean the airway between the downstem and the atomizer coil with the cleaning brush and some isopropyl alcohol.

5. Using isopropyl and a Q-tip, clean the area where the 710 coils would screw into the device.

6. Use a Q-tip and some isopropyl alcohol to clean out the atomizer coil.

7. Using a Q-tip and some isopropyl alcohol, clean around the carb cap and the device's body.

8. When the parts are dry, reassemble them.